F.S. Complete Set of Door Trims extracted from ES Lancer

ofey · Postby **ofey** » Thu Sep 24, 2009 7:32 am

ITEM: Complete Set of door trims extracted from ES Lancer

LOCATION: Melbourne, VIC

ITEM CONDITION: ES had done 1400KM at point of extraction

REASON FOR SELLING: ES wrecked. Providing direct sale service.

PRICE AND PAYMENT CONDITIONS: A$50 + Shipping / Direct Bank Transfer

EXTRA INFO:
- Excellent condition. May be used as a mod test sample. Priced to be cleared.

CONTACT INFO: via PM

PICTURES: Contact if Necessary

exaltd · Postby **exaltd** » Tue Sep 29, 2009 3:39 am

Did you get the quote for the rear quarter panel and the door for me?

And the VRX seats?

-EXALTD-

tadz0rz · Postby **tadz0rz** » Sat Oct 17, 2009 7:24 pm

Ofey, are these the entire door pannels or are they just the cloth trim pannel where you rest your arm?

Thanks man

ofey · Postby **ofey** » Fri Oct 23, 2009 6:24 am

The whole door panel.

JazzyB · Postby **JazzyB** » Fri Oct 23, 2009 7:08 am

Tadz! u should get 'em, mod 'em and sell 'em ;-)

Since ur becoming a bit of an interior nut! ;-)

cyssero · Postby **cyssero** » Sat Oct 24, 2009 3:35 pm

Are there any other parts FS? I've successfully scratched a few of the plastics in the interior and it would be nice to replace them (either new or wrecked). Thanks

JazzyB · Postby **JazzyB** » Mon Oct 26, 2009 7:19 am

I was wondering this, good question, any int/ext parts up for grabs?

Graham · Postby **Graham** » Tue Oct 27, 2009 12:34 pm

How much would it cost in postage to WA, a rough estimate?

I'm looking at doing my own leather door inserts and this would be good to practice on incase i screw it up..

I assume they would fit a VR too?

Cheers

ofey · Postby **ofey** » Tue Oct 27, 2009 1:01 pm

Answers:

No other parts. I went to the yard, and ripped out what I thought was of value. Even if there were interior bits, they're in bad nick. As the cars are left open air in the scrap. Rain or shine. We even found a dead rat dried out by the heat in a CJ.

Shipping to WA I think wouldn't be more than A$100. I wouldn't know. Too much effort for me to go to the wrecker, buy it, pack it and get a quote for you to say know. But I'm certain it won't be more than A$100

JazzyB · Postby **JazzyB** » Tue Oct 27, 2009 1:12 pm

How much for the sundried rat??? :-P

Sorry, bored!

bd-850 · Postby **bd-850** » Tue Oct 27, 2009 1:21 pm

can you get hte engine cover? if so how much and to post to 2666

F.S. Complete Set of Door Trims extracted from ES Lancer

F.S. Complete Set of Door Trims extracted from ES Lancer

Who is online