***** ALERT - Nominations for your new ClubCJ Committee can be made here *****
Buying a Ralliart
Moderator: Senior Moderators
Hey guys did not want to start a new thread so I thought i'd ask here.
Techsport vs RTR for an inspection. RTR is 3x the price of techsport so is it worth it. I know you get what you pay for but has anyone had good/bad experiences with either??
Ta!
Techsport vs RTR for an inspection. RTR is 3x the price of techsport so is it worth it. I know you get what you pay for but has anyone had good/bad experiences with either??
Ta!
Saying a car is for going form A to B is like saying sex is for reproduction!
mcpondy wrote:Hi Im new to this forum, Im thinking of buying a ralliart (08-10) mdel. Theres not much around in QLD. Does anyone here think 86k on 2008 is too much?
Depends. Make sure the gearbox has no issues, and that the engine has had its timing chain replaced with the revised design (2010 and up come with the new one from factory I believe).
AK 3" Single tip exhaust | 18x9 CST Zero 1 Hyper wheels |BC-BR Coilovers | UR UICP | Synapse DV | 3-pod A-Pillar | Adj. rear camber & toe arms | AK Aluminium undertray
86K on a 2008 car isn't too bad, I've got 75k on my 2009 RA. It will have no warranty so check the story you get fits the number of k's. Check service history, if it hasn't had the SST fluid changed factor in doing that. Don't think officially it's done until 100k but it should be done much sooner than that.
mcpondy wrote:Hi Im new to this forum, Im thinking of buying a ralliart (08-10) mdel. Theres not much around in QLD. Does anyone here think 86k on 2008 is too much?
Thread hijack!! LOL my 2010 RA just ticked over 86k km - to me, that many km on an 08 is on the lower side
MAP EF2 turbo , DW65 fuel pump, ID1000 injectors, EvoX FMIC, UR dump pipe, 100 cell cat, CP-E Exhaust, aFe air filter...and mud flaps!
86k does not seem excessive..thats approx 15-17k a year average so not too bad...but what the others have said...ensure the SST fluid has been changes if not do it immediately once you buy it..its not cheap and will cost you approx $800-1000.
Get it fully inspected at an evo specialist workshop if possible..drive the car and make sure gear changes are smooth..if you hear a few clunks from the SST here and there, thats pretty normal.
All the best with your purchase.
Get it fully inspected at an evo specialist workshop if possible..drive the car and make sure gear changes are smooth..if you hear a few clunks from the SST here and there, thats pretty normal.
All the best with your purchase.
Saying a car is for going form A to B is like saying sex is for reproduction!
Wow thanks for the quick reply guys. OK I'll check that stuff out. Here is the link...
I am going to a dealer cos I have to trade etc.
http://www.carsales.com.au/dealer/detai ... D-15744531
I am going to a dealer cos I have to trade etc.
http://www.carsales.com.au/dealer/detai ... D-15744531
my RA is a mid 09 build and its my daily drive
just got to 130k
as long as its servied and had the chain done its all good.
i would as a sweetner ask the dealer to reflush the sst
just got to 130k
as long as its servied and had the chain done its all good.
i would as a sweetner ask the dealer to reflush the sst
3Inch Custom Cat Back Exhaust
Home Brand Alloy UICP
DBA Slotted and Drilled Rotors
K&N Panel Filter Replacement
DBA Extreme Pads
Turbosmart Dual Port BOV
Tein S Tech Springs
Painted Calipers (Makes it look faster)
Home Brand Alloy UICP
DBA Slotted and Drilled Rotors
K&N Panel Filter Replacement
DBA Extreme Pads
Turbosmart Dual Port BOV
Tein S Tech Springs
Painted Calipers (Makes it look faster)
^ thats a good suggestion..
From the pics it does not look like a mitsubishi dealership so make sure they use the right fluid..say you want genuine mitsubishi SST fluid and get them to give you a receipt with the work done and fluid used just in case they are planning on putting in cheap fluid.
From the pics it does not look like a mitsubishi dealership so make sure they use the right fluid..say you want genuine mitsubishi SST fluid and get them to give you a receipt with the work done and fluid used just in case they are planning on putting in cheap fluid.
Saying a car is for going form A to B is like saying sex is for reproduction!
either that or the oem ford stuff
few threads here show its 99% the same stuff
word is some dealership in sydney use it aswell because its alot cheaper then the oem mitsu stuff
few threads here show its 99% the same stuff
word is some dealership in sydney use it aswell because its alot cheaper then the oem mitsu stuff
3Inch Custom Cat Back Exhaust
Home Brand Alloy UICP
DBA Slotted and Drilled Rotors
K&N Panel Filter Replacement
DBA Extreme Pads
Turbosmart Dual Port BOV
Tein S Tech Springs
Painted Calipers (Makes it look faster)
Home Brand Alloy UICP
DBA Slotted and Drilled Rotors
K&N Panel Filter Replacement
DBA Extreme Pads
Turbosmart Dual Port BOV
Tein S Tech Springs
Painted Calipers (Makes it look faster)
If its through a dealer, then perhaps ask for some warranty... most give it anyway, just for peace of mind, in case something is wrong. But yeah...
good luck dude. I just traded my 2008 MY09 RA with 82,000km in for another car.
good luck dude. I just traded my 2008 MY09 RA with 82,000km in for another car.
AK 3" Single tip exhaust | 18x9 CST Zero 1 Hyper wheels |BC-BR Coilovers | UR UICP | Synapse DV | 3-pod A-Pillar | Adj. rear camber & toe arms | AK Aluminium undertray
Return to “Thinking of Buying a Lancer?”
Who is online
Users browsing this forum: No registered users and 6 guests