What did you do on your car today?

[woollzz]

I know my ralliart will run a little lean with this on, but is it going to be a big deal if I have this on for a couple of weeks before getting a tune at the end of may??

[lancerdarryl]

Received uk 'X' badge to put next to the wording evolution on boot and received 'FQ' badge to replace MR badge

Picture when you get it on!
I did my "X" badge on the cheap........

[debonaire]

Just don't drive hard Michael, you'll be fine.

[Craker]

Got my car tuned by mrt using ecutek software. Goes so much harder now, like a different car.

[JJams6]

Cleaned some gunk of my car.....yelled at someone for leaning on my car do people not have any respect for people's car's haha stress so bad now I have a brand new car!
Still no mods yet just learning more about it every day

[Fawkes]

Gave it a wash and took my go-pro for a drive

[Syke]

while changing out my bulbs today i manage to break the wire piece that holds them in place so much frustration. not sure how i am going to fix it. Looks like im taking my front bumper off in the morning.

[eshanes]

Gave it a wash and took my go-pro for a drive [img:5e2947492b]http://www.clubcj.net/img/images/20130510173102_G0030060.JPG[/img:5e2947492b]

That's a great shot, Matt! What mounts do you use?
I've considered getting a GoPro White Edition, mainly for use while on my motorbike though.

[Fawkes]

[quote:688b6e1cd7=Fawkes]Gave it a wash and took my go-pro for a drive [img:5e2947492b]http://www.clubcj.net/img/images/20130510173102_G0030060.JPG[/img:5e2947492b][/quote:688b6e1cd7] Thats a great shot, Matt! What mounts do you use? Ive considered getting a GoPro White Edition, mainly for use while on my motorbike though.

Im using the motorsports mount (great big suction cup) mine is just the hero2 not the 3

[woollzz]

Installed AEM cold air intake on my ralliart today.

[bunnishiwa]

Installed AEM cold air intake on my ralliart today.

God they look sexy... Did you flash new maf settings to the ECU? Any noticeable power change? How does it sound?

When you going to get a hard UICP to offset it?

[woollzz]

Nah getting merlin to tune it at the end of the month so will take it easy til then. Not as much of a louder noise as I was hoping but it's all good.

Yea have been lookin at a couple hard UICPs, but what do you mean to "offset" it?

[bunnishiwa]

Oh - installed Grimspeed 3 port this afternoon. Words of warning though, don't rush a job because it starts raining - got the boost and actuator lines hooked up the wrong way round Found out after taking it for a run and there being very little power (even taking my conservative WGDC maps into account. All sorted now so will be working on the power curve over this week.

[SIX]

installed footwell LED's they are not working quite yet and not excatly sure why but will looking into it tomorrow , getting a lot of heat from the LED strips but not working ???