***** ALERT - Nominations for your new ClubCJ Committee can be made here *****

Adhesive bonnet protector/paint protector

Exterior Parts/Accessories & Modifications.

Moderators: Moderators, Senior Moderators

User avatar
Josh_Emerton
Lancer MASTER
Lancer MASTER
Posts: 1920
Joined: Fri Oct 17, 2008 10:49 pm
Location: Cairns, QLD, Australia

Postby Josh_Emerton » Sat May 23, 2009 3:05 am

Yep. I just dont bother with it. Just don't tailgate trucks and you should be fine.
Image

User avatar
Mizta B
Alumni
Alumni
Posts: 5867
Joined: Sun Dec 21, 2008 8:29 am
Location: Mortdale, NSW, Australia

Postby Mizta B » Sun May 24, 2009 2:43 pm

This film works a treat!
The soapy water trick for applying does work well My Dad and I have used it for years and this shouldnt cause any fade of paint pigments around it
Australasian Gerbil Rearers Organisation, Official Re-Seller.
Image
MY09 Rally Red VRX ClubCJ's 1st 4B12 2.4L - CCJ Lifetime Member #0004.
Merlinised....

User avatar
DavidAnthony
Lancer VRX/GTS
Lancer VRX/GTS
Posts: 329
Joined: Fri Mar 27, 2009 10:52 pm
Location: Sydney, NSW, Australia

Postby DavidAnthony » Sun May 24, 2009 2:54 pm

I am getting a clear bra soon, already have a small chip on the driver's side mirror. :(

Waiting for a quote from these guys:
http://www.ozicozi.com.au/

I hear they are the best.
RALLI//////ART

User avatar
spareparts
Lancer Ralliart
Lancer Ralliart
Posts: 662
Joined: Wed Apr 08, 2009 5:36 pm
Location: Mt Druitt, NSW, Australia

Postby spareparts » Sun May 24, 2009 3:14 pm

if its the same stuff i seen on at a car yard on a vy commo its looked funny after a while as f the clear coat of the car was liftin when i got closer i realised what it was
the voices may not be real, but they have some pretty good ideas :D:D
Image
..... If streets could talk they would Beg For Mercy!!! 151.6kw & 330nm @ all 4 paws .....

User avatar
LonePhantom
Lancer Newbie
Lancer Newbie
Posts: 73
Joined: Tue May 05, 2009 1:13 pm
Location: Canberra, ACT, Australia

Postby LonePhantom » Sun May 24, 2009 3:21 pm

Well I tried applying it yesterday to the nose of the car and wasn't too successful. :(

There are quite a few angles with it which made applying the contact far too difficult without a few creases and air bubbles. I ended up pulling it off.

I will however use it for the door sills, and probably along the rear bumper so it doesn't risk getting scuffed when loading stuff in the boot.

I'm going to get a regular bonnet protector this week I think.


Return to “Exterior”

Who is online

Users browsing this forum: No registered users and 105 guests