i went to my local mitsu service dept with a minor problem with my car that is annoying the shit out of me.
my heater/air vents wont stay put.
i prefer to have them pointed down, but no, after every bump they bounce up into my face
the service dept looked at the vent then looked at 2 other lancers handy, same problem
is this a design fault?
to ascertain this i need numbers of owners with the same problem.
set your fan to about half and see if the vent stays put please, and let me know
shut
bounced open
***** ALERT - Nominations for your new ClubCJ Committee can be made here *****
problem with adjustable air vents
Moderators: Moderators, Senior Moderators
Mine does it too. Except mine goes from pointing at me to pointing straight up.
And yeah only that driver's side vent.
How would it be a ralliart issue? Lol. Same vent, same dash, probably same aircon system..
I have seen other members mention it. I think it was in that 'What DON'T you like about your lancer' thread.
Mine at least isn't a wear and tear issue, at least not from me (maybe sun exposure) as I've never moved it other than to put it back
Edit: I'll confirm exactly what mine does at work tonight.
And yeah only that driver's side vent.
How would it be a ralliart issue? Lol. Same vent, same dash, probably same aircon system..
I have seen other members mention it. I think it was in that 'What DON'T you like about your lancer' thread.
Mine at least isn't a wear and tear issue, at least not from me (maybe sun exposure) as I've never moved it other than to put it back
Edit: I'll confirm exactly what mine does at work tonight.
LIST:
DOES:
sleeper
jake
julian
aaron
slash
naheen
DOESNT, MAY RECONSIDER AFTER EXENSIVE ROADS TRIALS:
matt
doreen
DOES:
sleeper
jake
julian
aaron
slash
naheen
DOESNT, MAY RECONSIDER AFTER EXENSIVE ROADS TRIALS:
matt
doreen
Last edited by sleeper on Sat Jul 09, 2011 11:13 am, edited 3 times in total.
I checked tonight and like I said, I point mine at my hand and soon after it'll be pointing up at nothing.
So, it seems to be that they are loose and bump up a bit from the spot you normally have them.
If we could get a letter from mitsu saying we can get them under warranty that would be good, so we could produce it if a service department acts like they won't do it.
So, it seems to be that they are loose and bump up a bit from the spot you normally have them.
If we could get a letter from mitsu saying we can get them under warranty that would be good, so we could produce it if a service department acts like they won't do it.
Who is online
Users browsing this forum: No registered users and 167 guests