Any advice or tips re taking the interior out?

[bunnishiwa]

Hi,

Can't find a thread so will ask. Anything I need to know regarding removing the seats, side trim, carpet, and particularly the center consol?

About to do this this weekend to dynamat and dynapad the floor for reduced road noise, and in advance of the kick ass premium system I'm going to be putting in over the next two months.

I know to unhook the battery (seat airbag light) first, and the seats just unbolt on each corner (?), and that the side trim 'unclips'. Just a bit unsure re the center consol and around the (CVT) gear stick. I'm assuming that it comes apart easily as no-one appears to have commented on it.

Any advice gratefully received

[stb01]

its all easy lol i have a vr 2010 and the center console is mainly clips but there are bolts that are in the center console comparment, two 10mm ones and then antother 2 at the front of th console under the gear selector assembly but start by removing the ash try then the hole where the heatet seat switches go (just in front of the cup holders ) there are plugs under neath it so dont rip it out lol and the side trims are just clips ececpt the one whis is loacted in the foot well there is a little push nut thats thee just twist off and they should all come out
and also regading the seats yes disconect the negitave side of the battery and wait 30 seconds or so as they hold charge not sure what bolts hold in the seats but they may be torx bits