Hey guys
im looking at upgrading my rims sometime soon, and i came across some that i liked.
can someone please Photoshop these rims onto my car, along with some VR sideskirts?
RIMS:
CAR:
Thanks.
***** ALERT - Nominations for your new ClubCJ Committee can be made here *****
Wheelz Photoshop
Moderators: Moderators, Senior Moderators
- TeejayDeejay
- Lancer Newbie
- Posts: 39
- Joined: Mon Aug 02, 2010 8:34 pm
- Location: Perth, Australia
- TeejayDeejay
- Lancer Newbie
- Posts: 39
- Joined: Mon Aug 02, 2010 8:34 pm
- Location: Perth, Australia
- TeejayDeejay
- Lancer Newbie
- Posts: 39
- Joined: Mon Aug 02, 2010 8:34 pm
- Location: Perth, Australia
- jolly_tas
- Lancer Ralliart
- Posts: 524
- Joined: Sun May 10, 2009 2:06 pm
- Location: Launceston, Tas, Australia
- Contact:
yeah i did... if you look carefully you can see that the concrete lines dont match up behind the rear wheel (from inside the wheel arch to behind the rear skirt) and also the shadows immediately in front of the car and down the side have not been blended where the darker shadow has been layered over top of the lighter shadow. While lowering it I also rotated the body (everything in the picture above the bottom edges of the car) around 5-7 degrees clockwise as the front looked too low. lol
- TeejayDeejay
- Lancer Newbie
- Posts: 39
- Joined: Mon Aug 02, 2010 8:34 pm
- Location: Perth, Australia
Who is online
Users browsing this forum: No registered users and 49 guests