FS: Cadence FXA-3001
Posted: Tue Jul 06, 2010 7:17 pm
Hey guys,
Up for sale is my old amp that was powering my Pioneer setup.
ITEM: Cadence FXA3001 Monoblock Amplifier
http://bit.ly/cVnunI
LOCATION: Sydney
ITEM CONDITION: Used - Comes without original box as i threw it out, But will provide in a box from my new 2ch amp for the buyer.
REASON FOR SELLING: Upgraded to Rockford setup and required a lesser power amp.
PRICE AND PAYMENT CONDITIONS: $180 Negotiable
SHIPPING AND POSTAL ARRANGEMENTS: Will post Australia Wide. But it is quite heavy, so post would come to $20 judging from my experience if you're up for it? (ofcouse will charge at cost) or Local Pick-Up is welcome.
EXTRA INFO: This amp was used to power 2 Pioneer woofers. Used in 2ohm mode. Gives plenty of stable power, never experienced a problem with it.
Details are as follows:
FXA-3001
MONO BLOCK POWER AMPLIFIER
4 ohm RMS Power: 1 x 300 Watts
2 ohm RMS Power: 1 x 500 Watts
Frequency Response: 20Hz - 300Hz
S/N Ratio: >100 db
Damping Factor: >200 @ 100Hz
Minimum THD: <0.05%
Fully Adustable Crossover
Bass Boost Equalization
High Level OEM Input
Lucite Encapulated Terminals
Dimensions: 13" x 11" x 2.75"
CONTACT INFO: PM me, or just Post below
PICTURES:
Up for sale is my old amp that was powering my Pioneer setup.
ITEM: Cadence FXA3001 Monoblock Amplifier
http://bit.ly/cVnunI
LOCATION: Sydney
ITEM CONDITION: Used - Comes without original box as i threw it out, But will provide in a box from my new 2ch amp for the buyer.
REASON FOR SELLING: Upgraded to Rockford setup and required a lesser power amp.
PRICE AND PAYMENT CONDITIONS: $180 Negotiable
SHIPPING AND POSTAL ARRANGEMENTS: Will post Australia Wide. But it is quite heavy, so post would come to $20 judging from my experience if you're up for it? (ofcouse will charge at cost) or Local Pick-Up is welcome.
EXTRA INFO: This amp was used to power 2 Pioneer woofers. Used in 2ohm mode. Gives plenty of stable power, never experienced a problem with it.
Details are as follows:
FXA-3001
MONO BLOCK POWER AMPLIFIER
4 ohm RMS Power: 1 x 300 Watts
2 ohm RMS Power: 1 x 500 Watts
Frequency Response: 20Hz - 300Hz
S/N Ratio: >100 db
Damping Factor: >200 @ 100Hz
Minimum THD: <0.05%
Fully Adustable Crossover
Bass Boost Equalization
High Level OEM Input
Lucite Encapulated Terminals
Dimensions: 13" x 11" x 2.75"
CONTACT INFO: PM me, or just Post below
PICTURES:
