Page 1 of 1
F.S. Complete Set of Door Trims extracted from ES Lancer
Posted: Thu Sep 24, 2009 7:32 am
by ofey
ITEM: Complete Set of door trims extracted from ES Lancer
LOCATION: Melbourne, VIC
ITEM CONDITION: ES had done 1400KM at point of extraction
REASON FOR SELLING: ES wrecked. Providing direct sale service.
PRICE AND PAYMENT CONDITIONS: A$50 + Shipping / Direct Bank Transfer
EXTRA INFO:
- Excellent condition. May be used as a mod test sample. Priced to be cleared.
CONTACT INFO: via
PM
PICTURES: Contact if Necessary
Posted: Tue Sep 29, 2009 3:39 am
by exaltd
Did you get the quote for the rear quarter panel and the door for me?
And the VRX seats?
-EXALTD-
Posted: Sat Oct 17, 2009 7:24 pm
by tadz0rz
Ofey, are these the entire door pannels or are they just the cloth trim pannel where you rest your arm?
Thanks man
Posted: Fri Oct 23, 2009 6:24 am
by ofey
The whole door panel.
Posted: Fri Oct 23, 2009 7:08 am
by JazzyB
Tadz! u should get 'em, mod 'em and sell 'em
Since ur becoming a bit of an interior nut!
Posted: Sat Oct 24, 2009 3:35 pm
by cyssero
Are there any other parts FS? I've successfully scratched a few of the plastics in the interior and it would be nice to replace them (either new or wrecked). Thanks
Posted: Mon Oct 26, 2009 7:19 am
by JazzyB
I was wondering this, good question, any int/ext parts up for grabs?
Posted: Tue Oct 27, 2009 12:34 pm
by Graham
How much would it cost in postage to WA, a rough estimate?
I'm looking at doing my own leather door inserts and this would be good to practice on incase i screw it up..
I assume they would fit a VR too?
Cheers
Posted: Tue Oct 27, 2009 1:01 pm
by ofey
Answers:
No other parts. I went to the yard, and ripped out what I thought was of value. Even if there were interior bits, they're in bad nick. As the cars are left open air in the scrap. Rain or shine. We even found a dead rat dried out by the heat in a CJ.
Shipping to WA I think wouldn't be more than A$100. I wouldn't know. Too much effort for me to go to the wrecker, buy it, pack it and get a quote for you to say know. But I'm certain it won't be more than A$100
Posted: Tue Oct 27, 2009 1:12 pm
by JazzyB
How much for the sundried rat???
Sorry, bored!
Posted: Tue Oct 27, 2009 1:21 pm
by bd-850
can you get hte engine cover? if so how much and to post to 2666