ClubCJ - The CJ Lancer Club

Hi all!

Have introduced myself so thought I would head on over.

New car, not much done yet.

Here's one of my aesthetic mods so far, blackout but with CF trim.
I posted in my intro thread that I will cut out FREE trims for anyone that wants it.

I can probably do 5, albeit $10 a pop (materials) plus labor (15 minutes each) but if you think it looks good, whether you already have a blacked out bar or not, hit me up.

I think it looks at least passable as you cannot detect the edges, anyone but a lancer owner would not know that piece is generally not sold in CF.

Like I said hit me up, you will most likely get it free if I can.

Looks sweet

Fizzlefuzzle wrote:Looks sweet

I think given yours is vrx with the chrome trim, I would need to adjust sizes so the CF comes up and tucks under your trim.

If you would like, PM me the distance between the chrome trim on the horizontal, (exact mm's) and I will cut out a blank. As long as your blackout was a "quality" spray, the vinyl will peel back off it any time.

You could be the first, what can go wrong, you don't like it, peel it off!

You couldn't beat this on ebay! Free goods, free shipping, plus possibly a nice looking front bar.
I have had at least two people ask me if it was actually real carbon fiber. Both were astonished it was not.

Another angle



If you can't be bothered measuring the trim I'll work it out for you.



Edit again- actually that is a bit confusing since your chrome trim / any blackout tappers on the edges out wards.

Either give me the total/max width at the bottom or...

I'll work it out for you instead, probably best if I cut over-sized then you can just apply then cut it back at the chrome. Don't worry I'll help you install it too, not just leave you with a strip of vinyl.
See I told you all I might be able to contribute. You guys/girls rock it!

:O I think, I want to do this to mine! :3 It looks nice!

I would like to do this to with my car too Mitch