ClubCJ - The CJ Lancer Club

Posted: **Sat May 19, 2012 3:03 pm**

will this fit?
its a handbrake cover and gearknob, sorry if this has been asked before
http://www.ebay.com.au/itm/Chrome-Leath ... 3866wt_944

http://www.ebay.com.au/itm/Royal-Leathe ... 3711wt_944

Posted: **Sat May 19, 2012 5:24 pm**

Don't know about the handbrake cover, but the knob should fit. Universal fitting and all.

Posted: **Sat May 19, 2012 6:01 pm**

The handbrake has measurements... I'm guessing you just jam it on, or maybe it has some fasteners at the bottom.

Get a ruler out or something

Fits diameter of 24mm apparently...

Posted: **Sat May 19, 2012 10:28 pm**

If you have a manual or CVT with a screw-on knob, the gearshift part shouldn't be a problem. The hand brake is the tricky bit though. Does the aftermarket part have an adjustment that will hold it tight? Because it would be nasty reaching for the hand brake with it going all over the place.

ClubCJ - The CJ Lancer Club

will these fit?

will these fit?