What did you do on your car today?

[The X]

BROKEN

[tim79b]

This is a little late (not technically today...more a labour of love/angst over the last couple of weeks!), but I have finally installed and tuned my new stereo:

- Pioneer AVH-4450BT Headunit
- JL Audio XD600/1 Monoblock Amp
- JL Audio XD400/4 4 Channel Amp
- Alpine SPS-610C Component Speakers (Front)
- Alpine SPS-610 Coaxial Speakers (Rear)
- JL Audio W3v3 sub in JL Audio Power wedge box
- Aerpro Double DIN fascia and steering wheel control harness

This is the first real mod I have made to the Lancer, and I was surprised at just how much easier it is to take apart than the other cars I have done previously. It was a little frustrating at times, but sounds AWESOME!!!

Pics Below...


(The Aerpro fascia fits pretty well - just a touch wide on the RHS)


I know, I need to clean some stuff out of the boot.

Need some Dynamat now

[timmo91]

Tim, that looks really nice. Wish I could do that stuff myself My boot vibrates quite a bit now since I got a sub too

[Mr Charisma]

Looks good Tim!

That JL box fits in surprising good.

[tim79b]

Looks good Tim! That JL box fits in surprising good.

Yeah - was a good fit...spent about 15 minutes running back and forth between the shop and the boot of the car with a tape measure before I bought it! Top to bottom it's tight, and the width leaves about 50mm to spare...

[Ballababy]

Installed my OEM VRX front air dams !

[damocr]

starting painting the calipers yellow today

[Syke]

New tint installed on the front today, doesnt match exactly but looks good
done by a place called Ming Toowoomba. $110 for installation




gas struts courtesy of body kits kingdom, bought them through ebay since their site said they had no stock. Easy Install

[bunnishiwa]

This is a little late (not technically today...more a labour of love/angst over the last couple of weeks!), but I have finally installed and tuned my new stereo: - Pioneer AVH-4450BT Headunit - JL Audio XD600/1 Monoblock Amp - JL Audio XD400/4 4 Channel Amp - Alpine SPS-610C Component Speakers (Front) - Alpine SPS-610 Coaxial Speakers (Rear) - JL Audio W3v3 sub in JL Audio Power wedge box - Aerpro Double DIN fascia and steering wheel control harness This is the first real mod I have made to the Lancer, and I was surprised at just how much easier it is to take apart than the other cars I have done previously. It was a little frustrating at times, but sounds AWESOME!!! Pics Below... [img:feb9821583]https://dl.dropbox.com/u/34766251/IMG_0683.jpg[/img:feb9821583] (The Aerpro fascia fits pretty well - just a touch wide on the RHS) [img:feb9821583]https://dl.dropbox.com/u/34766251/IMG_0685.jpg[/img:feb9821583] I know, I need to clean some stuff out of the boot. Need some Dynamat now

That is a nice set up Tim - love the JL stuff and the W3 in the box is an awesome sounding sub. As already said - nice fit - almost looks made to measure

[whitenight]

installed my upper i/c pipe that i made

[Bags]

I have a similar setup aswell Tim, that sub is a beast! You can give yourself a nice massage in the front seats with a nice old 808 beat!

[Fitter]

looks like some people trying to take my loudest lancer record....

and i hope someone on here does take it.

[FL_BLUE_LANCER_09]

looks like some people trying to take my loudest lancer record.... and i hope someone on here does take it.

lol im up for the challange. i got 2subs

just need to have it measured again after a few teaks to the setting and maybe i will take your title from you.

[tim79b]

looks like some people trying to take my loudest lancer record.... and i hope someone on here does take it.

Hey Fitter, where did you measure the SPL?