ClubCJ - The CJ Lancer Club

i have a set of angel eyes, my oven is too small and all i had was a hair dryer.
so i removed the headlights and began heating the seems with even passes (after removing the clip and screws of coarse) and started to pry into the sealent with a butter knife to try and seperate the lense from the headlight.
but it seemed all i was doing was starting to bend the plastic and i eventually gave up and put my car back together.

Is there anyone in queensland that could maybe help out sometime?
i will be in brisbane around the 26th of February if anyone is free.
or maybe any other helpful details in seperating the headlight?
heellp D:

awww man i had the same problem...

Lucky my parents owns a cafe they had a huge oven.. be careful because its pretty hard to put the assembly together sealed as good as it was

plus the headlights are huge btw never thought they were

haha, yeah they are huge, i did my brother's toyota supra headlights and they fit, so yeah, im kinda stuck... lol
i have sickaflex that i'll be adding to help re-seal them

try and take as much of the old sealant off... recommend yer sikaflex but in black the marine grade stuff

I would say try to get a heat gun from a hardware store.

yes correct over is the best and quickest but I have talked to a few people that took the time to use a heat gun it worked just took longer for the people who dont have a oven big enough

the oven we used was just too small. the door half closed but it still did the same job. Patience is the key while separating the lens to the headlight.

Just on this.

Not keen on:
1 - pulling apart my front end.
2 - sticking my headlights in an oven.

Does anybody know a place in Melbourne that will install them.
I can wire them up, I just need someone to put them in.