ClubCJ - The CJ Lancer Club

hey chanced upon this while lookin at piaa bulbs.....

http://www.sigmaautomotive.com/lighting/piaa.php

apparently u hook this up and it prevents ure signal lights from hyper flashing cuz of the lower wattage and also tells u wen the led bulb is blown...... but price is a lil dear.... rather save up for the rpw exhaust system now....

You can do the same thing for $5 off ebay....

Called a Load Resistor

but isnt is a lil hard to fit that in the housing for the bulb cuz its prdy cramped inside it rite?

It doesn't go in the light fitting itself. it's mounted out of it.

oh so it would be placed outside the light housing n bhind the protective carpet for the taillamps?

yes, connect to the wire, anywhere after the loom connector, the closer to the part regulated the better...

hmmmm will try that some time when i m free.....

SIR-VRX wrote:You can do the same thing for $5 off ebay....

Called a Load Resistor

Great tip!