ClubCJ - The CJ Lancer Club

Hi,
I have installed my innovate mtx-d boost gauge. Powers fine and everything but it always reads 40.8 any ideas what I did wrong? Thanks.

where have you connect the t-piece?
what guide did you use?

I out the T thing in the small hose that leads up to the Bov. So the just after the intake manifold (?). What do you mean by guide?

all good figured out the problem, the source wasn't grounded :S

cool.
throw up a vid on how it looks.

i just got a plain turbosmart one for my car.

Yeah sure will, I bought a dual gauge a pillar from the us for 200 shipped and then just put it in yesterday along with the wideband.

i wanted a pillar one so bad.
then i had a brain spaz one day and just drilled it into the steering colum plastic cover. lol

lol, it looks so much better and cleaner, was going to go out and take photo's but it started raining lol

yeah i think so to.
but when its on its bright and catches the attention of the 5-0

so im kinda happy its tucked away out of sight from people outside

yeah i haven't connected it with the headlights fuse so it dims when i use it at night. I'll have a look at night if its too bright then i'll use that if not then i won't bother.

akin6831 wrote:Yeah sure will, I bought a dual gauge a pillar from the us for 200 shipped and then just put it in yesterday along with the wideband.

Hey where'd you get the gauge pillar from? Can you post a link?

i got it from www.jcs-pods.com/‎ cheaper than the GB

I can't see an option for RHD? You did get RHD right?

yeah mine's RHD, when you get shipping to AUS, its RHD. Just confirm it with the maker before you buy.

phew!, lol, u had me worried Nick.