ClubCJ - The CJ Lancer Club

Hi all. Has anyone fitted Rally Armor (Ur series) flaps to a sportback....im assuming that the front will fit but the rear wont. Thx

Yes. Me and Bandit have. The rears do not fit (as in hole but I can take a picture tmr and show you what I did).

There are two ways you can do this:

1) drill holes into the rear flap to accodmadate the rear arch bolts -or-

2) just screw the self tapering screws into the rear arch plastic guards inside the wheel arch.

It'll make sense when I take apic.

Thx heaps Bruno...could you take some pics of your hatch from the back as well. Cheers

Hey Bruno. Noticed you had the MMCS with ipod cable...what functions does it give you on your ipod.....in the manual it looks like you have all ipod controls etc... and where does it plug in?

I will try to take some pictures tmr... ipod control is fully functional with the MMCS (playlist etc), until the car starts moving then it locks out most of the functions - there is a work around by slash but requires some wire splicing

Here is a pic o f the rear mudflap screws:

The main two are visible and probably don't need much alteration at all (lengthening of the holes with a drill bit).

The last screw which is a bit hard to see, you can get away without drilling at all and don't use their L- connector to create a screw point for it... doesn't really fit the sportback and will stick into the wheel too much.

What I did was just screw into the plastic guard itself. Hard to take a pic though. So:

||====[spacer]====> Guard