Posted: Sat Jul 09, 2011 4:56 pm
same as what your looking at but from SSV http://ssv.com.au/product.php?2371
maybe you can price haggle
ClubCJ - The CJ Lancer Club
Sports back XDC rear skirt (fibresports)
Page 1 of 1
Posted: Sat Jul 09, 2011 5:02 pm
didnt look at price
maybe you can price haggle
maybe you can price haggle
Posted: Sat Jul 09, 2011 5:09 pm
not too sure, only ever dealt with SSV once and didnt have problem.
as for fitting, all depends on how skilled you are
as for fitting, all depends on how skilled you are
Posted: Sat Jul 09, 2011 5:33 pm
Or you could spray the back bumper like me...
Posted: Sat Jul 09, 2011 6:20 pm
Nothing wrong with Fibresports. I know of a couple of people who have used them.
Fitment should not be too bad if it is ABS plastic. If fibreglass, you will get more fitment issues.
You should do a fitment test before painting.
Fitment should not be too bad if it is ABS plastic. If fibreglass, you will get more fitment issues.
You should do a fitment test before painting.
Posted: Sat Jul 09, 2011 9:09 pm
I think you will have to cut the bumper... especially the part that sticks out at the bottom - one of the reasons why I didn't get a rear body kit...
Posted: Thu Oct 06, 2011 4:22 pm
milobob wrote:I think you will have to cut the bumper... especially the part that sticks out at the bottom - one of the reasons why I didnt get a rear body kit...
I just recieved an email from them regrding this product: Rear Skirt XDC (CJ005)
Its a direct bolt on, just need sikaflex 227 in the middle section
Get 4 screws (2 for near wheel arch, 2 for middle, plasitc strip that runs along the edge wher it meets the rear bar
Its quite an easy rear skirt to fit
All up $240