ClubCJ - The CJ Lancer Club

Hi brothers

have if I can help

My car is a sportback to inform finish, come without side skirts and I have bought from a friend who has put in his car the evo kit

are painting the car for the full insurance

And the kid's workshop, I said you need a template to know where to make holes in the plate of the car.

Anyone know if this template? or I'll have to manufacture it myself? as would be the way to place and are perfect?

Thank you very much in advance, I put a couple of pictures for you to see how it has been after painting, is not finished yet.





srry my english its google traductor

I am not sure if any template does exist, maybe best to use some tape and spend some time getting them right by eye.

Does the inside of the extension (side skirt) have drill markings? If so, possibly copy those to a sheet to copy to the car?

Spanish?

¿El interior de la extensión (lateral falda) tienen marcas de perforación? Si es así, posiblemente copiar esos a una hoja de copiar en el coche?

Or maybe Portuguese?

O interior da extensão (saia lateral) têm marcas de perfuração? Se assim for, eventualmente copiar os para uma folha para copiar para o carro?

That is as good as I can get Google to translate...

thanks for the answers

The side skirt is each 10 staples that are stuck in 10 holes have to ask the car in front of the plate.

Then below are also 5 screws each.

And then takes double-layer tape all along the side skirt.

In the official manual mitsubishi explain assembly with a rubber washers are also dual-layer tape. Put them in each of the holes in the clamps press against the side skirt and car washers are stuck on the plate, marking the holes.

But do not find it anywhere these washers, I guess I'll have to grease staining or painting nails and doing the same procedure.

We make a paper template I see the truth very cumbersome.

Well now I will be reporting on how it goes

Greetings and thanks from Spain