ClubCJ - The CJ Lancer Club

The rear spoiler on our RX has a snaped off bolt and was going to get the dealer to replace the spoiler with a new one but Ilike the look of the Evo X one.
Question is do these fit the same bolt holes as the standard spoiler and do the fit on a RX Lancer.

Cheers
Millsy

I think from memory 1hole lines up each side, the others need to be drilled...

The front and back holes need to be drilled as far as I'm aware, there are 3 holes in total.

If you open the boot they are outlined in a circle so you'll notice it, you could just plug/silicone up the hole that the RX spoiler used and drill a third hole for the evo spoiler.