ClubCJ - The CJ Lancer Club

I've seen pictures of people blacking out the middle section of their front bar with vinyl though recently I saw a member on here with the entire middle section removed and meshed over though I can't seem to find it again.

I'm guessing this would have been done by a body shop but does anyone know if this would affect the car at all? From what I've seen I can't see that middle section doing anything important besides holding the number plate.

Are you sure they removed the entire centre peice. Maybe it was just one of the EVO X peices you install of the existing centre piece.

That would be meee lol and it's all photoshop. But should be doable. (Russian's have it down pat).



Mate, you should probably have done a bit more of a thorough search - i know its a weird topic, but there are a few flying around.

Doable maybe but not without reinforcing the front bar as in the centre area there are a lot of housings and supports.

im sure it could be done but would be tricky.

Its a bug collector xD

Options would be to create crossbars BEHIND the mesh