***** ALERT - Nominations for your new ClubCJ Committee can be made here *****
Adhesive bonnet protector/paint protector
Moderators: Moderators, Senior Moderators
- Josh_Emerton
- Lancer MASTER
- Posts: 1920
- Joined: Fri Oct 17, 2008 10:49 pm
- Location: Cairns, QLD, Australia
This film works a treat!
The soapy water trick for applying does work well My Dad and I have used it for years and this shouldnt cause any fade of paint pigments around it
The soapy water trick for applying does work well My Dad and I have used it for years and this shouldnt cause any fade of paint pigments around it
Australasian Gerbil Rearers Organisation, Official Re-Seller.
MY09 Rally Red VRX ClubCJ's 1st 4B12 2.4L - CCJ Lifetime Member #0004.
Merlinised....
MY09 Rally Red VRX ClubCJ's 1st 4B12 2.4L - CCJ Lifetime Member #0004.
Merlinised....
- DavidAnthony
- Lancer VRX/GTS
- Posts: 329
- Joined: Fri Mar 27, 2009 10:52 pm
- Location: Sydney, NSW, Australia
I am getting a clear bra soon, already have a small chip on the driver's side mirror.
Waiting for a quote from these guys:
http://www.ozicozi.com.au/
I hear they are the best.
Waiting for a quote from these guys:
http://www.ozicozi.com.au/
I hear they are the best.
RALLI//////ART
- spareparts
- Lancer Ralliart
- Posts: 662
- Joined: Wed Apr 08, 2009 5:36 pm
- Location: Mt Druitt, NSW, Australia
if its the same stuff i seen on at a car yard on a vy commo its looked funny after a while as f the clear coat of the car was liftin when i got closer i realised what it was
the voices may not be real, but they have some pretty good ideas :D
..... If streets could talk they would Beg For Mercy!!! 151.6kw & 330nm @ all 4 paws .....
..... If streets could talk they would Beg For Mercy!!! 151.6kw & 330nm @ all 4 paws .....
- LonePhantom
- Lancer Newbie
- Posts: 73
- Joined: Tue May 05, 2009 1:13 pm
- Location: Canberra, ACT, Australia
Well I tried applying it yesterday to the nose of the car and wasn't too successful.
There are quite a few angles with it which made applying the contact far too difficult without a few creases and air bubbles. I ended up pulling it off.
I will however use it for the door sills, and probably along the rear bumper so it doesn't risk getting scuffed when loading stuff in the boot.
I'm going to get a regular bonnet protector this week I think.
There are quite a few angles with it which made applying the contact far too difficult without a few creases and air bubbles. I ended up pulling it off.
I will however use it for the door sills, and probably along the rear bumper so it doesn't risk getting scuffed when loading stuff in the boot.
I'm going to get a regular bonnet protector this week I think.
Who is online
Users browsing this forum: No registered users and 54 guests