***** ALERT - Nominations for your new ClubCJ Committee can be made here *****

Rattles!

Lancer Interior Modifications.

Moderators: Moderators, Senior Moderators

User avatar
scraverX
Lancer MASTER
Lancer MASTER
Posts: 1590
Joined: Fri Oct 30, 2009 8:12 am
Location: Canberra, Australia
Contact:

Postby scraverX » Sun Aug 22, 2010 7:24 am

My Parcel shelf would rattle (partly due to my subs ;) ) if I didn't have pieces of felt wedged between it and the rear glass.
"Max" 2009 MY10 RX, Black. CCJ Lifetime Premium Member #0125
Car & Home audio nut.
Car audio brands used: Audison, Eclipse, Hybrid Audio Technology, Precision Power, Polk Audio, Pioneer PRS
Home Audio: Denon, Epos, Pro`ject, AKG

User avatar
milobob
Lancer Legend
Lancer Legend
Posts: 1130
Joined: Mon Aug 31, 2009 6:16 pm
Location: Melbourne

Postby milobob » Sun Aug 22, 2010 11:06 am

blu_art wrote:3)Rattle that comes from passenger side glove box is caused by the bottom cover which is under the glove box. Remove this bottom cover by removing the two clips. add some tape around two pointy plastics on the botom cover & then add a thin layer or padding on top of the bottom cover. Now put it back & put two clips.


Yes I forgot to mention I did this too. When I installed my mirrors I found that this piece was loose causing a bit of rattling - however taping it I found didn't stop the rattles from the glovebox completely so my method of wiring up the glovebox piston works.

I suppose I only get the stereo rattle on bumpy country rods where the temperature is quite low... hardly ever, even less so the instrument rattle. On normal city driving/highways I don't hear a thing.


For YOU GUYS with the DOOR RATTLES: What I found with our Outlander was that the tinting people broke one of the clips that hold the WHITE DOOR CLIP into the door. This caused the WHITE CLIP to be loose and fall out to the bottom cavity of the door - rattling whenever you drive on certain rougher roads above a certain speed.

If you think you have a rattle in the door - I suggest taking it apart and checking to see if there is anything floating at the bottom of the door cavity - AND check to see if all the white clips are still in place! :)

Hope this helps some people.
2010 RenaultSport Megane RS250 Cup Trophee (Xenons+Leather+Front Parkers)

User avatar
shamrockshirts
Lancer Ralliart
Lancer Ralliart
Posts: 584
Joined: Mon May 25, 2009 2:20 pm
Location: Sydney, NSW, Australia
Contact:

Postby shamrockshirts » Sun Aug 22, 2010 11:53 am

Just tried the Glovebox fix (however the piston wasn't loose and didn't rattle when I tested it). BUT I found the plastic panel/kickplate under the glove box was stupidly loose. I suspect this is the actual source of my rattle.

User avatar
AcTiv driver
INACTIVE Member Account
Posts: 1
Joined: Sat Sep 18, 2010 8:26 pm
Location: Central Coast AU

Postby AcTiv driver » Sat Sep 18, 2010 8:38 pm

I bought an Activ in April this year. Within 3 months I had rattles! Very disappointing to say the least. Couldn't believe it when I found this post, with people having problems in the same areas as myself.
I have an IRRITATING rattle coming from the passenger side vent area, possibly the glove box, however it doesn't seem like there is any problem with it. Plastic on plastic, like something is loose. Too scared to remove anything for the fear that the rattle will bring 3 more friends along. Also, had a creaking noise from the rear passenger side of the car, when turning the corner or an incline or decline from driveways. Contacted my Mitsu dealer, and discussed the creaking along with OTHER problems (rattling front windows when 1/4 or 1/2 open, and faulty bluetooth system), and since then, have not heard the creek once. Fingers crossed it doesn't return. However before i went to the dealer, I did notice my rear bumper made a creek when i pushed it up, so i'm assuming they may have tightened the bumper. They are also replacing the front windows AND bluetooth system. Apparently the windows are a KNOWN issue in the OUTLANDER but not the Lancer. Not sure of what to do with the dash noise, perhaps just pretend it doesn't exist, or wear earplugs? :-P

User avatar
dannyboi
Lancer Evolution
Lancer Evolution
Posts: 818
Joined: Sat Jun 26, 2010 8:53 pm
Location: Sydney, Australia

Postby dannyboi » Sat Sep 18, 2010 10:00 pm

Drove to Canberra today, and the glove box was going crazy. I think I'm going to find some sort of glass bumper or even masking tape to dampen the sound.
It almost feels like that silver trim is rubbing against the glove box. If I press the glove box in, then the rattle stops.

User avatar
robnkel
Lancer Newbie
Lancer Newbie
Posts: 37
Joined: Sun Mar 21, 2010 4:55 pm
Location: Tasmania

Postby robnkel » Thu Oct 07, 2010 1:10 am

Got me a rattle now also.
4,500 ks 7 months old.
Somewhere behind the stereo.
Got one around the glove box too, open it and shut it again and its gone.
The one behind the stereo only comes up when cruising the highway, 5th gear.
Shitful!!!
2010 Lancer Activ

User avatar
liam92
Lancer VRX/GTS
Lancer VRX/GTS
Posts: 306
Joined: Fri Jul 02, 2010 8:47 pm

Postby liam92 » Thu Oct 07, 2010 9:13 am

Ive got steering column rattles, Im yet to have a go at fixing it but finally found it yesterday! the bottom plate closest to your legs is making alot of noise

sunstealth
INACTIVE Member Account
Posts: 11
Joined: Sat Sep 12, 2009 1:37 pm
Location: blainville,quebec,canada

Postby sunstealth » Sat Oct 23, 2010 12:24 pm

rattles try a front end squeak which turned out to be both front strut top plates were shot at 1300 kilometres.

A thud/thump and creak sound in the trunk/boot area turned out to be an area where the spot weld failed, it had to be repaired under warranty took almost a full week.

the C pillar airbag plastic covers were constantly falling off, luckily yesterday the head mecanic at a DIFFERENT mitsu dealership fixed the problem. window tinters break the retaining clips and it does'nt show off till they get a little abbraded by vibrations.

and all the others you mentionned are there, but particularly the front door handles area.

User avatar
JaCe
Alumni
Alumni
Posts: 1819
Joined: Thu Jun 04, 2009 7:17 am
Location: Sydney, AU

Postby JaCe » Sat Oct 23, 2010 1:29 pm

I've noticed my car has a lot of rattles even since it was new :(

Bit of a pity but from what I can tell in reading reviews in magazines (I think it was MOTOR?), the Evo X actually involves quite a lot of manual labour in the construction/assembly process which probably explains the inconsistencies.

That being said, it's still better than my Mum's Jaguar which has varying gaps everywhere!
Image

"A man who stands for nothing, falls for anything."

Fisherrr
Lancer Newbie
Lancer Newbie
Posts: 63
Joined: Sat Aug 28, 2010 12:59 am
Location: Mount Waverley, VIC

Postby Fisherrr » Sat Oct 30, 2010 11:22 pm

Here is what specialist guys are saying about lancer dashboard:

Under dash space:
Wires - bare without anti-rattle braids, and indeed the dashboard consists of many pieces, which rub against each other, creating sounds. Moreover, the dashboard doesn't have enough fasteners to the frame (which we counted about 8 pieces only), which further stimulates her "walk" on the bumps.

Image

Full story on dashboard soundproofing (sorry it is in Russian)
http://www.auto-loker.ru/photoset_10.shtml


I would love to do the same, just not sure how to disassemble and then put it back.

chris851
Lancer VR/GT
Lancer VR/GT
Posts: 255
Joined: Wed Oct 06, 2010 9:51 am
Location: Mawson Lakes

Door Rattles

Postby chris851 » Thu Dec 02, 2010 3:47 pm

Hey dose any one have bad rattles in the door handles? sounds like a spring... when i thump my hand over the handle.

User avatar
JaCe
Alumni
Alumni
Posts: 1819
Joined: Thu Jun 04, 2009 7:17 am
Location: Sydney, AU

Postby JaCe » Thu Dec 02, 2010 3:51 pm

lol i've had rattles in my car since the day i got it... sometimes here, sometimes there.
Image



"A man who stands for nothing, falls for anything."

User avatar
Gleno
Lancer Evolution
Lancer Evolution
Posts: 991
Joined: Sun Sep 05, 2010 12:22 pm
Location: Sydney

Postby Gleno » Thu Dec 02, 2010 5:01 pm

I have the odd rattle here and there,near the glove box and near the side pillar,cant seem to pinpoint it though,mainly on course roads i hear them.Seems to be ok on a smooth road.

User avatar
dannyboi
Lancer Evolution
Lancer Evolution
Posts: 818
Joined: Sat Jun 26, 2010 8:53 pm
Location: Sydney, Australia

Postby dannyboi » Sun Dec 05, 2010 7:02 pm

Removed the glovebox for the first time to tape the clips for the piston. Will see how it goes, as the rattling is happening in suburban driving.


Return to “Interior”

Who is online

Users browsing this forum: No registered users and 29 guests