Hey all,
Just wondering if you guys have the same issue.
I'm referring to the dark grey fabric/plastic liner that surrounds the left and right sides of the boot. I noticed that on the left side, where there appears to be a cut-out pattern, it's sagging down a lot and is not flushed at all.
The nearest plastic screw isn't doing a particularly good job either, as the hole has torn so there's not much grip anymore.
I only spotted it as I was trying to see where I could place a strip of LEDs.
I'll take a photo once the weather clears.
Cheers,
Danny
***** ALERT - Nominations for your new ClubCJ Committee can be made here *****
Boot Liner Issue?
Moderators: Moderators, Senior Moderators
Well once you put the pics up I might be able to help. I had my whole interior stripped out a while ago, then I put it back in, just for sh!ts and giggles
But I think my boot setup is a little different to yours though.
Jase
But I think my boot setup is a little different to yours though.
Jase
I'm back baby!
Enkei - HKS - Turbosmart - Cosworth- TMW - Defi - DeatschWerks
Enkei - HKS - Turbosmart - Cosworth- TMW - Defi - DeatschWerks
Going through the LED thread, I spotted Hoge's photo:
If you look at the liner, it looks pretty warped. The sag point should really be flushed to the top of boot, and fitting tightly around some electrical cables.
I guess that suggests it's a "problem" for other cars. It doesn't really affect anything, but it does seem out of place and is a quality issue.
I'll take a photo tomorrow anyway.
If you look at the liner, it looks pretty warped. The sag point should really be flushed to the top of boot, and fitting tightly around some electrical cables.
I guess that suggests it's a "problem" for other cars. It doesn't really affect anything, but it does seem out of place and is a quality issue.
I'll take a photo tomorrow anyway.
Who is online
Users browsing this forum: No registered users and 67 guests