***** ALERT - Nominations for your new ClubCJ Committee can be made here *****
WTB: Ralliart Exhaust
Moderators: Moderators, Senior Moderators
- spunkybob
- Lancer MASTER
- Posts: 1605
- Joined: Thu Dec 04, 2008 11:36 am
- Location: Kariong, NSW, Australia
ash06 wrote:So first to get a hold of one then off to an exhaust shop it is.
spunkybob are you trying to hijack my thread lol or mocking me hehe
haha, I'm actually interested in getting 1 also so no point posting when I can take all your glory
I PM'd ofey last night and this is what he said.
"Well if you're saying straight on, you'll need a pretty talented muffler guy as you know our wheel well sits lower than the RA. The problem though is that if you sit it too close to that wheel well you will get vibrations through the chassis of the car as the muffler will rattle against it.
My muffler guy said the best way is to cut and weld so it can increase the distance between the muffler and the wheel well.
I went for the 2nd method.
So in question, I'll say yes it will but better if you cut and weld."
So basically, you need to get it modded as it wont bolt strain onto the rear flange or be low enough.
Who is online
Users browsing this forum: No registered users and 33 guests